Front Seat Inner Belt Assembly: Removal: Removal

HINT: 

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY  . Refer to REMOVAL - Step 2
2. REMOVE FRONT SEAT ASSEMBLY 
   1. Remove the front seat assembly. Refer to REMOVAL .
3. REMOVE COWL TOP VENTILATOR LOUVER RH  . Refer to REMOVAL - Step 1
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   WARNING: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
   NOTE:

   • w/ Navigation System (for HDD):

     After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

     Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal

     Condition	Waiting Time
     Vehicle enrolled in safety connect system	6 minutes
     Vehicle not enrolled in safety connect system	1 minute

   • When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
5. REMOVE FRONT SEAT INNER BELT ASSEMBLY 
   Fig 1: Identifying Front Seat Inner Belt Assembly Harness Connectors And Clamp

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. for Driver Seat:

      Disconnect the 3 connectors and detach the 5 clamps.

   2. for Passenger Seat:

      Disconnect the 2 connectors and detach the clamp.

   3. Remove the nut and front seat inner belt assembly.
      Fig 2: Identifying Front Seat Inner Belt Assembly Nut

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002