Trunk Lid Actuator: Removal: Removal

REMOVE COWL TOP VENTILATOR LOUVER RH . Refer to REMOVAL - Step 1

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE:

w/ Navigation System (for HDD):

After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal

Condition	Waiting Time
Vehicle enrolled in safety connect system	6 minutes
Vehicle not enrolled in safety connect system	1 minute

When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY See step 3
REMOVE ROPE HOOK See step 5
REMOVE DECK TRIM SIDE BOARD LH See step 4
REMOVE DECK TRIM SIDE BOARD RH See step 7
REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY See step 8
REMOVE NO. 2 LUGGAGE COMPARTMENT TRIM HOOK (w/o Rear Cooler) See step 9
REMOVE NO. 1 COOLER COVER (w/ Rear Cooler) . Refer to INSTALLATION - Step 21
REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER See step 11
REMOVE REAR FLOOR FINISH PLATE See step 12
REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH See step 13
REMOVE LUGGAGE CLOSER MOTOR ASSEMBLY
1. Disconnect the connector.
  
  Fig 1: Locating Trunk Lid Actuator Connector, Bolts And Nut Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 3 bolts and nut.
3. Remove the luggage closer motor.