Rear Seat Heater does not Operate Through Front Switch: Procedure
- READ VALUE USING TECHSTREAM (SEAT HEATER SWITCH)
- Use the Data List to check if the rear sunshade switch is functioning properly.CENTER CONSOLE SWITCH
Tester Display Measurement Item/Range Normal Condition Diagnostic Note Rear Seat Heater Main Switch Rear seat heater main switch signal/ON or OFF ON: Rear seat heater main switch ON
OFF: Rear seat heater main switch OFF- OK
On screen, each item changes between ON and OFF according to above chart.
NG → See step 2
OK → REPLACE COMBINATION SWITCH ASSEMBLY (NO. 1 CONSOLE SWITCH)
- Use the Data List to check if the rear sunshade switch is functioning properly.
- INSPECT INTEGRATION CONTROL & PANEL ASSEMBLY (NO. 2 CONSOLE SWITCH)
- Disconnect the No. 2 console switch connector.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
Tester Connection Switch Condition Specified Condition 6 - 8 Rear seat heater main switch is pushed Below 200 Ω 6 - 8 Rear seat heater main switch is not pushed 10 kΩ or higher
NG → See step 3
OK → REPLACE COMBINATION SWITCH ASSEMBLY (NO. 1 CONSOLE SWITCH)
- REPLACE INTEGRATION CONTROL & PANEL ASSEMBLY (NO. 2 CONSOLE SWITCH). Refer to REMOVAL