DTC B15C2: Speed Signal Malfunction: Description

The display and navigation module display receives a vehicle speed signal from the combination meter assembly and information from the GPS antenna, and then adjusts the vehicle position.

The display and navigation module display stores this DTC when the difference between the speed information that the navigation antenna assembly receives and the SPD pulse received from the combination meter assembly becomes large.

HINT: 

• A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.
• If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.