Satellite Switch Circuit: Procedure
- INSPECT SATELLITE SWITCH
- Disconnect the J16 connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Switch Condition Specified Condition 2 (LSFT) - 5 (E) Satellite switch LH is pressed Below 1 Ω 2 (LSFT) - 5 (E) Satellite switch LH is not pressed 10 kΩ or higher 3 (SET) - 5 (E) Satellite switch ON/OFF is pressed Below 1 Ω 3 (SET) - 5 (E) Satellite switch ON/OFF is not pressed 10 kΩ or higher 4 (RSEL) - 5 (E) Satellite switch RH is pressed Below 1 Ω 4 (RSEL) - 5 (E) Satellite switch RH is not pressed 10 kΩ or higher
NG → See step 3
OK: Go to next step
- CHECK HARNESS AND CONNECTOR (COMBINATION METER - SATELLITE SWITCH)
- Disconnect the J35 connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition J35-5 (RSEL) - J16-4 (RSEL) Always Below 1 Ω J35-6 (LSEL) - J16-2 (LSFT) Always Below 1 Ω J35-7 (SET) - J16-3 (SET) Always Below 1 Ω J16-2 (LSFT) - Body ground Always 10 kΩ or higher J16-3 (SET) - Body ground Always 10 kΩ or higher J16-4 (RSEL) - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 4
- REPLACE SATELLITE SWITCH. Refer to REMOVAL - Step 5
- REPLACE COMBINATION METER. Refer to REMOVAL - Step 9