Hybrid System Indicator Malfunction: Procedure

1. Check for the DTC. Refer to DIAGNOSIS SYSTEM .

   Result

   Result	Proceed to
   CAN communication DTC is not output and EV drive mode indicator light has a malfunction.	A
   CAN communication DTC is output.	B

B → See step   7 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical/Combination Meter/Active Test.
5. Check the indicator light operation according to the values in the table below.
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   HV System Indicator	HV System Indicator	MIN, -50, 0, 100, 200, 300, 400, MAX	Confirm that the vehicle is stopped, power switch on (READY)

   OK

   Hybrid system indicator indication is normal.

NG → See step   5 

OK: Go to next step 

1. Connect Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical/Combination Meter/Active Test.
5. Check the indicator light operation according to the values in the table below.
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Hybrid System Indicator	Hybrid system indicator value/ Min.: -512, Max.: 512	-512 to 512	-

   OK

   Hybrid system indicator value displayed on the Techstream is almost the same as hybrid system indicator indication.

NG → See step   6 

OK: Go to next step 

1. Replace the combination meter assembly with a new or a known good one. Refer to REMOVAL .

   OK

   The operation of the hybrid system indicator returns to normal.

NG → See step   8 

OK → END