DTC B1635/24: Rear Airbag Sensor LH Circuit Malfunction: Procedure

1. Turn the power switch off.
   Fig 1: Identifying Side Airbag Sensor RH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the cable from the negative (-) auxiliary battery terminal.
   WARNING:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

3. Interchange the No. 2 side airbag sensor assembly LH with RH and connect the connectors to them.
4. Connect the cable to the negative (-) auxiliary battery terminal.
5. Turn the power switch on (IG), and wait for at least 60 seconds.
6. Clear the DTCs stored in memory. Refer to DTC CHECK / CLEAR .
7. Turn the power switch off.
8. Turn the power switch on (IG), and wait for at least 60 seconds.
9. Check for DTCs. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC B1635/24 is output.	A
   DTC B1630/23 is output.	B
   DTCs B1630/23 and B1635/24 are not output.	C

   TEXT IN ILLUSTRATION
   
   

   *1	No. 2 Side Airbag Sensor Assembly RH
   *2	Side Airbag Sensor Assembly LH

   HINT: 

   Codes other than DTCs B1630/23 and B1635/24 may be output at this time, but they are not related to this check.

B → See step   3 

C → See step   2 

A → See step   4