Accessory Meter: Removal: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL . Refer to REMOVAL - Step 33
REMOVE ACCESSORY METER ASSEMBLY
1. Remove the 3 screws.
  
  Fig 1: Remove the 3 screws & Disengage the 2 clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disengage the 2 clips.
3. Disconnect each connector and remove the accessory meter assembly.