LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2011 >> RX 350 AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brake System (Hydraulic) (Service Information) >> Brake Pedal >> Reassembly >> Reassembly

Brake Pedal: Reassembly: Reassembly

  1. INSTALL STOP LIGHT SWITCH CUSHION (for TMC Made) 
    1. Install the stop light switch cushion to the brake pedal sub-assembly.
  2. INSTALL BRAKE PEDAL BUSHING (for TMC Made) 
    1. Apply lithium soap base glycol grease to 2 new brake pedal bushings.
    2. Install the 2 brake pedal bushings to the brake pedal sub-assembly.
  3. INSTALL BRAKE PEDAL SHAFT COLLAR (for TMC Made) 
    1. Install the brake pedal shaft collar to the brake pedal sub-assembly.
  4. INSTALL BRAKE PEDAL SUB-ASSEMBLY (for TMC Made) 
    1. Install the brake pedal sub-assembly to the brake pedal support sub-assembly with the bolt and nut as shown in the illustration.
      Fig 1: Remove The Bolt, Nut And Brake Pedal Sub-Assembly
      GTY284135Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 37 N*m (375 kgf*cm, 27 ft.*lbf) 

    2. Engage the 2 clamps.
      Fig 2: Engage the 2 clamps
      GTY257196Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL BRAKE PEDAL PAD 
    1. Install the brake pedal pad.
scientia non olet · About LEMON Manuals