Brake Master Cylinder: Disassembly: Disassembly

REMOVE BRAKE MASTER CYLINDER TO WAY TUBE
1. Mount the brake master cylinder sub-assembly in a vise.
  NOTE:
  Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.
2. Using a union nut wrench, remove the brake master cylinder to way tube from the No. 2 brake tube way and brake master cylinder body.
  
  Fig 1: Remove/Install No. 2 Brake Tube Way At Brake Master Cylinder Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 2 BRAKE TUBE WAY
1. Remove the No. 2 brake tube way from the brake master cylinder body.
REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
1. Mount the brake master cylinder sub-assembly in a vise.
  
  Fig 2: Tapping Straight Pin
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.
2. Using a pin punch and a hammer, tap out the straight pin, and remove the brake master cylinder reservoir sub-assembly.
REMOVE MASTER CYLINDER RESERVOIR GROMMET
1. Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir assembly.