Driver Side Seat Belt Warning Light does not Operate: Procedure

1. Clear the DTC. Refer to DTC CHECK / CLEAR .
2. Recheck for DTCs.

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B → See step   3 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Perform the Active Test according to the display on the Techstream.
   COMBINATION METER (COMBINATION METER ASSEMBLY)
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Driver Side Seat Belt	Driver side seat belt warning light	OFF or ON	Confirm that the vehicle stopped with the engine idling

   OK

   The driver side seat belt warning light on the combination meter assembly operates normally.

NG → See step   4 

OK → See step   5