DTC B1582: Map Disk Reading Malfunction: Procedure
- CHECK MAP DISC
- Check that the map disc is not deformed or cracked.
OK
No deformations or cracks on the map disc
NG → REPLACE MAP DISC
OK: Go to next step
- Check that the map disc is not deformed or cracked.
- DISC CLEANING
- Disc cleaning
- If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.NOTE:
Do not use a conventional record cleaner or anti-static preservative.
- If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.
NEXT: Go to next step
- Disc cleaning
- CHECK DTC
- Clear the DTC. Refer to DTC CHECK / CLEAR .
- Recheck for DTCs and check if the same DTC is output again.
OK
No DTC is output.
NG → See step 4
OK → See step 5
- REPLACE NAVIGATION MODULE BOARD. Refer to REMOVAL
- USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING