Only Rear Switch Cannot Operate Rear Sunshade: Procedure
- CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
- Clear the DTCs. Refer to DTC CHECK / CLEAR .
- Check for DTCs. Refer to DTC CHECK / CLEAR
.RESULT
Result Proceed to DTC is not output A DTC U0210 is output B
B → See step 7
A: Go to next step
- CHECK VEHICLE EQUIPMENT
- Check if the vehicle is equipped with the Ottoman.RESULT
Result Proceed to for 5-Passenger with Ottoman, w/o Ottoman A except 5-Passenger with Ottoman B
B → See step 6
A: Go to next step
- Check if the vehicle is equipped with the Ottoman.
- READ VALUE USING TECHSTREAM (REAR CONSOLE SWITCH)
- Use the Data List to check if the rear sunshade switch is functioning properly. Refer to DATA LIST / ACTIVE TEST
.REAR CONSOLE SWITCH
Tester Display Measurement Item/Range (Display) Normal Condition Diagnostic Note Rear Shade Switch Rear sunshade switch / ON or OFF ON: Rear sunshade switch is pressed
OFF: Rear sunshade switch is not pressed- OK
Rear sunshade raises or lowers.
NG → See step 4
OK → See step 8
- Use the Data List to check if the rear sunshade switch is functioning properly. Refer to DATA LIST / ACTIVE TEST
.
- CHECK HARNESS AND CONNECTOR (CURTAIN SWITCH - REAR POWER SEAT SWITCH)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- Disconnect the r3 curtain switch connector.
- Disconnect the r1 rear power seat switch connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition r3-8 (SW1) - r1-20 (SW1) Always Below 1 Ω r3-15 (GND) - r1-5 (GND) Always Below 1 Ω r3-8 (SW1) - Body ground Always 10 kΩ or higher r3-15 (GND) - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: Go to next step
- CHECK CURTAIN SWITCH ASSEMBLY
- Temporarily replace the curtain switch assembly with a new or normally functioning one. Refer to REMOVAL .
- Check that the rear sunshade can be raised and lowered by using the curtain switch assembly.
OK
Rear sunshade can be raised and lowered with curtain switch assembly
NG → See step 11
OK → END (CURTAIN SWITCH IS DEFECTIVE)
- READ VALUE USING TECHSTREAM (REAR CONSOLE SWITCH)
- Use the Data List to check if the rear sunshade switch is functioning properly. Refer to DATA LIST / ACTIVE TEST
.REAR CONSOLE SWITCH
Tester Display Measurement Item/Range (Display) Normal Condition Diagnostic Note Rear Shade Switch Rear sunshade switch / ON or OFF ON: Rear sunshade switch is pressed
OFF: Rear sunshade switch is not pressed- OK
Rear sunshade raises or lowers.
NG → See step 9
OK → See step 10
- Use the Data List to check if the rear sunshade switch is functioning properly. Refer to DATA LIST / ACTIVE TEST
.
- GO TO CAN COMMUNICATION SYSTEM. Refer to DTC U0210: Lost Communication with "Seat Control Module C"
- USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
- REPLACE REAR POWER SEAT SWITCH. Refer to REMOVAL - Step 1
- USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
- REPLACE REAR POWER SEAT SWITCH. Refer to DISASSEMBLY