Odo/Trip Switch Malfunction: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. Check the values by referring to the table below.
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   ODO/TRIP Change SW	ODO/TRIP change switch/OFF or ON	OFF: ODO/TRIP change switch released	-
   		ON: ODO/TRIP change switch pressed

   OK

   The value displayed on the Techstream changes with the actual ODO/TRIP change switch operation.

NG → See step   2 

OK → See step   5 

1. Remove the trip switch. Refer to REMOVAL .
   Fig 1: Identifying Trip Switch Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   10 (A/B) - 11 (E)	ODO/TRIP switch on (pushed)	Below 1 Ω
   	ODO/TRIP switch off (not pushed)	1 MΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *a	Component without harness connected (Trip Switch)

NG → See step   4 

OK: Go to next step 

1. Disconnect the G3 meter connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G3-11 (RSET) - G64-10 (A/B)	Always	Below 1 Ω
   G64-11 (E) - Body ground	Always	Below 1 Ω
   G3-11 (RSET) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   5