DTC B2414: Steering Position Sensor Malfunction: Procedure

CHECK FOR DTC
1. Clear the DTCs. Refer to DTC CHECK / CLEAR .
2. Check for DTCs. Refer to DTC CHECK / CLEAR .
  OK
  
  DTC B2414 output does not occur.
NG → See step 2

OK → See step 6
REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY (STEERING ANGLE SENSOR)
1. Temporarily replace the spiral cable with a new or normally functioning one. Refer to REMOVAL .
NEXT: Go to next step
CHECK FOR DTC
1. Clear the DTCs. Refer to DTC CHECK / CLEAR .
2. Recheck for DTCs. Refer to DTC CHECK / CLEAR .
  OK
  
  DTC B2414 output does not reoccur.
NG → See step 4

OK → See step 5
REPLACE HEADLIGHT SWIVEL ECU ASSEMBLY. Refer to REMOVAL
END (REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY). Refer to REMOVAL
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING