Washer Nozzle (for Rear Side)

WIPER / WASHER: WASHER NOZZLE (for Rear Side): ADJUSTMENT

PRECAUTION OF WASHER NOZZLE ADJUSTMENT

(a) Do not clean or adjust the washer nozzle with a safety pin, etc. for the following reasons:

(1) The washer nozzle tip is made of resin and could be damaged.

(2) Adjustment is not necessary for this spray-type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.

(b) If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.

1. ADJUST REAR WASHER NOZZLE SUB-ASSEMBLY

(a) Using a screwdriver, adjust the direction of the rear washer nozzle.





HINT
Use a thin-bladed screwdriver with an approximately 1 mm (0.0394 in.) thick tip.

NOTICE:
Do not use a safety pin or other pointed tools. Doing so may damage the inside of the washer nozzle.