Installation

DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY: INSTALLATION

1. INSTALL PROPELLER SHAFT ASSEMBLY

(a) Align the matchmarks on the propeller shaft flange and differential flange.

(b) Install the propeller shaft assembly with the 4 bolts, 4 washers and 4 nuts.

Torque : 88 Nm (899 kgf-cm, 65 ft-lbf)

(c) Align the matchmarks on the propeller shaft flange and transfer flange.

(d) Install the propeller shaft assembly with the 4 washers and 4 nuts.

Torque : 88 Nm (899 kgf-cm, 65 ft-lbf)