Installation

AXLE AND DIFFERENTIAL: REAR DIFFERENTIAL CARRIER ASSEMBLY: INSTALLATION

1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

(a) Install a new gasket and the differential carrier assembly with the 10 nuts and 10 washers.

Torque : 52 Nm (530 kgf-cm, 38 ft-lbf)

2. INSTALL REAR AXLE SHAFT LH

(a) Install the rear axle shaft LH Installation.

3. INSTALL REAR AXLE SHAFT RH

HINT
Use the same procedure described for the LH side.

4. INSTALL PROPELLER SHAFT ASSEMBLY

(a) Install the propeller shaft assembly Installation.

5. ADD DIFFERENTIAL OIL Service and Repair