Installation

AXLE AND DIFFERENTIAL: FRONT AXLE HUB: INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

(a) Apply MP grease to a new O-ring.

(b) Install the O-ring to the axle hub.

(c) Install the dust cover and axle hub to the steering knuckle with the 4 bolts.

Torque : 80 Nm (816 kgf-cm, 59 ft-lbf)

2. INSTALL FRONT AXLE SHAFT NUT

(a) Clean the threaded parts on the drive shaft and axle shaft nut using a non-residue solvent.

(b) Install the front axle shaft nut.

Torque : 235 Nm (2396 kgf-cm, 173 ft-lbf)

(c) Install the adjusting cap and a new cotter pin.

3. INSTALL FRONT AXLE HUB GREASE CAP

(a) Install a new axle hub grease cap.

NOTICE:
Make sure the grease cap is securely installed to the axle hub.

4. INSTALL FRONT DISC Installation

5. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH Installation

6. INSTALL FRONT WHEEL

Torque : 112 Nm (1137 kgf-cm, 82 ft-lbf)

7. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(a) Inspect and adjust the front wheel alignment Front Wheel Alignment.

8. CHECK SPEED SENSOR SIGNAL

(a) Inspect the speed sensor signal Installation.