Installation

SUSPENSION CONTROL: ABSORBER CONTROL SWITCH: INSTALLATION

1. INSTALL COMBINATION SWITCH ASSEMBLY (ABSORBER CONTROL SWITCH)

(a) Install the combination switch (absorber control switch) with the 4 screws.

2. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

3. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

4. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

5. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.