Installation

SUSPENSION CONTROL: ABSORBER CONTROL ACTUATOR: INSTALLATION

1. INSTALL SUSPENSION CONTROL BRACKET LH

(a) Using SST, install the bracket with the nut.





SST : 09961-00950

Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)

2. INSTALL ABSORBER CONTROL ACTUATOR LH

(a) Using a hexagon wrench (4 mm), install the absorber control actuator with the 2 hexagon socket head cap bolts.

Torque : 7.8 Nm (80 kgf-cm, 69 in-lbf)

NOTICE:
Replace the absorber control actuator with a new one if it is dropped.

(b) Connect the connector, and then attach the 3 clamps.

NOTICE:
Securely connect the connector.

3. INSTALL FRONT WHEEL Installation

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.