Installation

STEERING COLUMN: STEERING WHEEL: INSTALLATION

1. INSTALL STEERING WHEEL ASSEMBLY

(a) Align the matchmarks on the steering wheel assembly and steering main shaft assembly.

(b) Install the steering wheel assembly set nut.

Torque : 50 Nm (510 kgf-cm, 37 ft-lbf)

2. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY Installation

3. INSTALL CRUISE CONTROL MAIN SWITCH Installation

4. INSTALL STEERING PAD SWITCH ASSEMBLY

(a) Attach the 2 claws to install the steering pad switch assembly.

(b) Install the 4 screws.

(c) Connect the connector.

5. INSTALL STEERING PAD ASSEMBLY Installation

6. INSTALL NO. 2 STEERING WHEEL LOWER COVER Installation

7. INSTALL NO. 3 STEERING WHEEL LOWER COVER Installation

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

9. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.