Installation

POWER ASSIST SYSTEMS: VANE PUMP: INSTALLATION

1. INSTALL VANE PUMP ASSEMBLY

(a) Install the vane pump with the 2 bolts.

Torque : 43 Nm (438 kgf-cm, 32 ft-lbf)

2. CONNECT PRESSURE FEED TUBE

(a) Install a new gasket to the pressure feed tube.

(b) Connect the pressure feed tube and install the union bolt.

Torque : 50 Nm (510 kgf-cm, 37 ft-lbf)

HINT
Make sure the stopper of the pressure feed tube touches the vane pump.

3. CONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR

(a) Connect the connector.

4. CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

(a) Connect the No. 1 oil reservoir to pump hose to the vane pump assembly with the clip.

5. INSTALL FAN AND GENERATOR V BELT Installation

6. INSTALL RADIATOR SUPPORT UPPER SEAL Installation

7. INSTALL AIR CLEANER CASE Installation

8. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

9. INSTALL AIR CLEANER CAP AND HOSE Installation

10. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

11. INSTALL FRONT FENDER APRON SEAL RH Installation

12. INSTALL FRONT WHEEL RH

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

14. ADD POWER STEERING FLUID

15. BLEED POWER STEERING FLUID On-Vehicle Inspection

16. INSPECT FOR POWER STEERING FLUID LEAK