Installation

1UR-FE STARTING: STARTER: INSTALLATION

1. INSTALL FLYWHEEL HOUSING SIDE COVER

2. INSTALL STARTER ASSEMBLY

(a) Install the starter with the 2 bolts.

Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

(b) Connect the starter connector.

(c) Connect the starter wire with the nut.

Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

(d) Attach the starter wire clamp.

3. INSTALL STARTER COVER

(a) Install the starter cover with the 3 bolts.

Torque : 12 Nm (117 kgf-cm, 8 ft-lbf)

4. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH

(a) Install the exhaust manifold sub-assembly RH Installation.

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.