Installation

SEAT BELT: REAR NO. 2 SEAT INNER BELT ASSEMBLY: INSTALLATION

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT
A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL REAR NO. 2 SEAT INNER BELT ASSEMBLY LH

(a) Using a T45 "TORX" socket wrench, install the inner belt assembly with the bolt.

Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

2. INSTALL REAR SEAT CUSHION LOWER HINGE COVER LH Reassembly

3. INSTALL REAR NO. 2 SEAT ASSEMBLY LH

(a) Install the rear No. 2 seat assembly LH Installation.