Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION ECU: INSTALLATION

1. INSTALL OCCUPANT CLASSIFICATION ECU

(a) Attach the claw to install the occupant classification ECU.





NOTICE:
If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant classification ECU with a new one.

(b) Connect the 2 connectors.

NOTICE:
When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

2. INSTALL FRONT SEAT ASSEMBLY RH

HINT
Refer to the procedure from Install Front Seat Assembly Installation.

3. ZERO POINT CALIBRATION AND SENSITIVITY CHECK

(a) Perform zero point calibration and the sensitivity check Pinout Values and Diagnostic Parameters.

4. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check Reading and Clearing Diagnostic Trouble Codes.

5. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.