Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Front Passenger Side): INSTALLATION

1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

(a) Connect the connector.





NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Attach the 6 claws to install the instrument panel airbag.

(c) Install the 3 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

2. INSTALL LOWER INSTRUMENT COVER LH Installation

3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

4. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

5. INSTALL COWL SIDE TRIM BOARD RH Installation

6. INSTALL DOOR SCUFF PLATE ASSEMBLY RH Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.