Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Driver Side): INSTALLATION

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

(a) Connect the connector.





NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Install the airbag assembly with the 4 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

3. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

5. INSTALL COWL SIDE TRIM BOARD LH Installation

6. INSTALL DOOR SCUFF PLATE ASSEMBLY LH Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.