Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/ Rear No. 2 Seat)

(a) Install the curtain shield airbag with the 17 new bolts.

Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

NOTICE:
Do not twist the curtain shield airbag when installing it.

(b) Connect the connector.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/o Rear No. 2 Seat)

(a) Install the curtain shield airbag with the 13 new bolts.

Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

NOTICE:
Do not twist the curtain shield airbag when installing it.

(b) Connect the connector.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

3. INSTALL NO. 1 AIR DUCT REAR SIDE (w/ Rear Air Conditioning System) Installation

4. INSTALL NO. 2 AIR DUCT REAR SIDE (w/ Rear Air Conditioning System) Installation

5. INSTALL ROOF HEADLINING ASSEMBLY

(a) Install the roof headlining Installation.