Brake Lamp Relay: Testing and Inspection

LIGHTING (EXT): STOP LIGHT CONTROL RELAY: INSPECTION

1. INSPECT STOP LIGHT CONTROL RELAY ASSEMBLY

(a) Disconnect the A6 stop light control relay connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





If the result is not as specified, repair or replace the wire harness or connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





If the result is not as specified, repair or replace the wire harness or connector.

Text in Illustration





(d) Reconnect the A6 stop light control relay connector.





(e) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





If the result is not as specified, replace the stop light control relay.

Text in Illustration