Installation

1UR-FE EMISSION CONTROL: AIR INJECTION DRIVER: INSTALLATION

1. INSTALL AIR INJECTION CONTROL DRIVER

(a) Install the air injection control driver with the 2 screws.

Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

2. INSTALL AIR INJECTION CONTROL DRIVER WITH BRACKET

(a) Install the air injection control driver with bracket with the bolt.

Torque : 13 Nm (127 kgf-cm, 9 ft-lbf)

(b) Connect the 2 air injection control driver connectors.

3. INSTALL ENGINE ROOM SIDE COVER LH Installation