Installation

1UR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION

1. INSTALL FAN AND GENERATOR V BELT

(a) Set the fan and generator V belt onto every part.





Text in Illustration





(b) While turning the belt tensioner counterclockwise, remove the pin.

NOTICE:
Make sure that the fan and generator V belt is properly set on each pulley.

(c) Check that the belt fits properly in the ribbed grooves.

HINT
Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

2. INSTALL UPPER RADIATOR SUPPORT SEAL Installation

3. INSTALL V-BANK COVER SUB-ASSEMBLY Installation