Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: CRAWL SWITCH: INSTALLATION

1. INSTALL COMBINATION SWITCH ASSEMBLY (CRAWL CONTROL SWITCH)

(a) Install the combination switch (crawl control switch) with the 4 screws.

2. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

3. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

4. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

5. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

6. PERFORM CRAWL CONTROL CALIBRATION

(a) Perform crawl control calibration Programming and Relearning.