Installation

BRAKE (FRONT): FRONT BRAKE FLEXIBLE HOSE: INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. INSTALL FRONT FLEXIBLE HOSE

(a) Using a union nut wrench, connect the brake tube to the front flexible hose while holding the front flexible hose with a wrench to install the front flexible hose.

Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

NOTICE:
* Do not bend or damage the brake tube.
* Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
* Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Service Precautions.

(b) Install 2 new clips to the front flexible hose.

2. BLEED BRAKE LINE Service and Repair

3. INSTALL FRONT WHEEL Installation