ABS Warning Light does not Come ON

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: ABS Warning Light does not Come ON
- ABS Warning Light does not Come ON

DESCRIPTION

Refer to ABS Warning Light Remains ON ABS Warning Light Remains ON.

WIRING DIAGRAM

Refer to ABS Warning Light Remains ON ABS Warning Light Remains ON.

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration Programming and Relearning.

PROCEDURE

1. INSPECT ABS WARNING LIGHT

(a) Disconnect the 2 skid control ECU connectors.

(b) Turn the engine switch on (IG).

(c) Check that the ABS warning light comes on.

OK:

ABS warning light comes on.

NG -- CHECK CAN COMMUNICATION LINE

OK -- REPLACE MASTER CYLINDER SOLENOID Disassembly

2. CHECK CAN COMMUNICATION LINE ABS Warning Light Remains ON

NG -- GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) How to Proceed With Troubleshooting
OK -- Continue to next step.

3. READ VALUE USING TECHSTREAM (ABS WARNING LIGHT) ABS Warning Light Remains ON

B -- REPLACE MASTER CYLINDER SOLENOID Disassembly

A -- GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) How To Proceed With Troubleshooting