Reassembly

EXTERIOR PANELS / TRIM: REAR SPOILER: REASSEMBLY

HINT
When installing the rear spoiler protector, heat the rear spoiler surface using a heat light.

Standard:





1. INSTALL REAR NO. 1 SPOILER PROTECTOR





(a) When using a new rear spoiler:

(1) Clean the rear spoiler surface.

(2) Using a heat light, heat the rear spoiler surface.

(b) When reusing the rear spoiler:

(1) Using a heat light, heat the rear spoiler surface.

(2) Remove the double-sided tape from the rear spoiler.

(3) Wipe off any tape adhesive residue with cleaner.

(c) Install a new rear No. 1 spoiler protector.

(1) Remove the peeling paper from the face of a new rear No. 1 spoiler protector.

HINT
After removing the peeling paper, keep the exposed adhesive free from foreign matter.

(2) Install the rear No. 1 spoiler protector.

2. INSTALL REAR SPOILER SIDE PROTECTOR LH





(a) When using a new rear spoiler:

(1) Clean the rear spoiler surface.

(2) Using a heat light, heat the rear spoiler surface.

(b) When reusing the rear spoiler:

(1) Using a heat light, heat the rear spoiler surface.

(2) Remove the double-sided tape from the rear spoiler.

(3) Wipe off any tape adhesive residue with cleaner.

(c) Install a new rear spoiler side protector.

(1) Remove the peeling paper from the face of a new rear spoiler side protector.

HINT
After removing the peeling paper, keep the exposed adhesive free from foreign matter.

(2) Install the rear spoiler side protector.

3. INSTALL REAR SPOILER SIDE PROTECTOR RH

HINT
Use the same procedure described for the LH side.