Canada - Interior - Front Seat Back Pocket Loose
BulletinL-TCI-3059
Issue Date
October 24, 2011
Title:
FRONT SEAT BACK POCKET LOOSE
Service Category
Vehicle Interior
Section
Seat
Market
Canada
APPLICABILITY:
INTRODUCTION:
Some vehicles may exhibit a condition where the top of the front seat back pocket becomes detached or has pulled away from the assembly. A new part with improved durability has been developed to address this condition.
PRODUCTION CHANGE INFORMATION:
This TSB applies to vehicles produced BEFORE the Production Change Effective VIN shown.
PARTS INFORMATION:
WARRANTY INFORMATION:
REPAIR PROCEDURE:
1. Remove the entire Front Seat Assembly.
Refer to TIS, applicable model and model year Repair Manual:
Refer to the Repair Manual within E-TAS / TIS library, applicable model year.
- 2010 / 2011 GX460:
Vehicle Interior - Seat - "Front Seat Assembly: Removal"
- 2010 / 2011 GX460:
Vehicle Interior - Seat - "Front Seat Assembly: Disassembly"
HINT
Remove the headrest and set the seat back straight up and in the middle position before removing.
2. Replace the front seatback board sub-assembly LH. (The procedure is the same for both the LH and RH side).
A. Detach the 2 hooks and disconnect the 2 rubber bands.
B. Move the cover in the direction of the arrow to detach the 2 claws.
C. Move the cover in the direction of the arrow to detach the 2 guides and remove the seatback board.
3. Reassemble the seat assembly using a NEW Front Seatback Board Sub-Assembly.
2010 / 2011 GX460:
Vehicle Interior - Seat - "Front Seat Assembly: Reassembly"
4. Install front seat assembly.
2010 / 2011 GX460:
Vehicle Interior - Seat - "Front Seat Assembly: Installation"
NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available.
IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.