Installation

THEFT DETERRENT / KEYLESS ENTRY: ENGINE HOOD COURTESY SWITCH: INSTALLATION

1. INSTALL HOOD LOCK ASSEMBLY

(a) Apply MP grease to the sliding areas of the lock.





(b) Connect the hood lock control cable assembly.

(c) Connect the connector.

(d) Install the hood lock assembly with the 3 bolts.

Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)

2. INSTALL HOOD LOCK CONTROL CABLE COVER

(a) Pass the hood lock control cable assembly through the hood lock control cable cover.

(b) Attach the claw to install the hood lock control cable cover.

(c) Install the 2 bolts.

Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)

3. INSTALL LOW PITCHED HORN ASSEMBLY Installation

4. INSTALL HIGH PITCHED HORN ASSEMBLY Installation

5. INSTALL HOOD LOCK RELEASE LEVER PROTECTOR

(a) Attach the 2 claws and 2 guides to install the hood lock release lever protector.

6. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) Installation

7. INSTALL RADIATOR GRILLE Installation

8. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) Adjustments

9. INSTALL UPPER RADIATOR SUPPORT SEAL Installation

10. INSTALL ENGINE ROOM SIDE COVER LH Installation