Combination Meter: Installation: Installation

INSTALL COMBINATION METER ASSEMBLY
1. Connect the 2 connectors as shown.
  
  Fig 1: Connecting Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the combination meter assembly as shown.
  
  Fig 2: Installing Combination Meter Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the 4 screws.
  
  Fig 3: Locating Combination Meter Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
1. Engage the guide and 4 claws.
  
  Fig 4: Identifying Instrument Cluster Finish Panel Sub-Assembly Claws And Guide, Clips And Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Engage the 2 clips.
3. Install the instrument cluster finish panel sub-assembly with the screw.
INSTALL STEERING COLUMN COVER
1. Engage the claw and install the upper steering column cover.
  
  Fig 5: Identifying Steering Column Cover Upper Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Engage the 2 claws.
  
  Fig 6: Identifying Lower Steering Column Cover With Screws And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the lower steering column cover with the 2 screws.
  Torque: 2.0 N*m (20 kgf*cm, 18 in.*lbf)
INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 44
INSTALL INSTRUMENT PANEL FINISH PANEL END LH . Refer to INSTALLATION - Step 45
INSTALL SIDE INSTRUMENT PANEL LH . Refer to INSTALLATION - Step 46
INSTALL FRONT DOOR OPENING TRIM COVER LH . Refer to INSTALLATION - Step 42
INSTALL FRONT DOOR SCUFF PLATE LH . Refer to INSTALLATION - Step 43
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal. Refer to INITIALIZATION .