Inspection Procedure
NOTE:
- Before performing troubleshooting, inspect the connectors of related circuits.
- Before replacing the suspension control ECU, perform all of the following again: 1) symptom simulation. Refer to HOW TO PROCEED WITH TROUBLESHOOTING ; 2) DTC inspection. Refer to DTC CHECK / CLEAR ; and 3) Techstream inspection (Data List or Active Test). Refer to DATA LIST / ACTIVE TEST . If no malfunctions are found in other areas, replace the suspension control ECU.
- If the suspension control ECU is replaced, the vehicle height offset calibration and registration of vehicle identification information must be performed. Refer to CALIBRATION and. Refer to REGISTRATION )