LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> RX 350 FWD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt (Service Information) >> Front Seat Outer Belt Assembly With PRETENSIONER >> REMOVAL (To 8/2009) >> Removal

REMOVAL (To 8/2009): Removal

  1. PRECAUTION (w/ Navigation System for HDD) 
    NOTE:

    After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  3. REMOVE FRONT DOOR SCUFF PLATE  . Refer to REMOVAL - Step 3
  4. REMOVE REAR DOOR SCUFF PLATE  . Refer to REMOVAL - Step 7
  5. REMOVE LOWER CENTER PILLAR GARNISH  . Refer to REMOVAL - Step 8
  6. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY 
    1. Remove the bolt and disconnect the floor end of the front seat outer belt assembly.
      Fig 1: Remove The Bolt And Disconnect The Floor End
      GTY270963Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE CENTER PILLAR GARNISH  . Refer to REMOVAL - Step 10
  8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY 
    1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
      Fig 2: Remove The Nut And Disconnect The Shoulder Anchor
      GTY287495Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.
      Fig 3: Disconnect The Pretensioner Connector
      GTY275751Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Tape the screwdriver tip before use.

    3. Disconnect each connector.
    4. Remove the 2 bolts and front seat outer belt assembly.
      Fig 4: Locating Front Seat Outer Belt Bolts
      GTY288934Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY 
    1. Remove the 2 bolts.
      Fig 5: Identifying 2 bolts
      GTY273518Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guide and remove the front shoulder belt anchor adjuster assembly.
scientia non olet · About LEMON Manuals