DTC B1695/16: Door Side Airbag Sensor LH Malfunction: Procedure

1. Turn the engine switch off.
   Fig 1: Checking Side Airbag Sensor LH (For Front Side)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the cable from the negative (-) battery terminal.
   NOTE:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. Interchange the side airbag sensor RH (for front side) with side airbag sensor LH (for front side) and connect the connectors.
4. Connect the cable to the negative (-) battery terminal.
5. Turn the engine switch on (IG), and wait for at least 60 seconds.
6. Clear the DTCs stored in the memory. Refer to DTC CHECK / CLEAR .
7. Turn the engine switch off.
8. Turn the engine switch on (IG), and wait for at least 60 seconds.
9. Check for DTCs. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC B1695/16 is output.	A
   DTC B1690/15 is output.	B
   DTC B1690/15 and B1695/16 are not output.	C

   TEXT IN ILLUSTRATION
   
   

   *1	Side Airbag Sensor RH (for Front Side)
   *2	Rear Airbag Sensor LH

   HINT: 

   Codes other than DTC B1690/15 and B1695/16 may be output at this time, but they are not related to this check.

C → See step   4 

B → See step   3 

A → See step   2