DTC B1000/31: Center Airbag Sensor Assembly Malfunction (To 8/2009): Procedure

CHECK CENTER AIRBAG SENSOR ASSEMBLY
1. Turn the engine switch on (IG), and wait for at least 60 seconds.
2. Clear the DTCs stored in the memory. Refer to DTC CHECK / CLEAR .
3. Turn the engine switch off.
4. Turn the engine switch on (IG), and wait for at least 60 seconds.
5. Check for DTCs. Refer to DTC CHECK / CLEAR .
  OK
  
  DTC B1000/31 is not output.
NG → See step 3

OK → See step 2
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
REPLACE CENTER AIRBAG SENSOR ASSEMBLY. Refer to REMOVAL