Voice is not Recognized (From 8/2009): Procedure

1. Display the "Voice Settings" screen.
2. Check that "Voice Recognition Guidance" is not "Off".
   Fig 1: Screen Display - Voice Recognition Guidance

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK

   "Voice Recognition Guidance" is not "Off".

NG → TURN VOICE RECOGNITION GUIDANCE "On" 

OK: Go to next step 

1. Check that the map disc is not deformed or cracked.
   Fig 2: Ensure Map Disc Is Not Cracked Or Deformed

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK

   No deformations or cracks on the map disc

NG → REPLACE MAP DISC 

OK: Go to next step 

1. Check for dirt on the map disc surface.
   Fig 3: Cleaning Disc With Soft Cloth

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK

   No dirt is on the map disc surface.

   NOTE:

   Do not use a conventional record cleaner or anti-static preservative.

   HINT: 

   If dirt on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

NG → CLEAN MAP DISC 

OK: Go to next step 

1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

   HINT: 

   • A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
   • The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.

   OK

   Condensation is not likely being produced and the temperature is not high or extremely low.

NG → SET CABIN TO APPROPRIATE TEMPERATURE 

OK: Go to next step 

1. Enter the "Check Mic&Voice Recognition" (Microphone&Voice Recognition Check). Refer to OPERATION CHECK .
   Fig 4: Screen Display - Microphone & Voice Recognition Check

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
3. Push the recording switch and perform voice recording.

   HINT: 

   • Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.
   • Voice can be recorded up to 5 seconds.
4. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

   OK

   All check results are normal.

NG → See step   6 

OK → See step   7