INSTALLATION (To 8/2009): Installation

INSTALL LIGHT CONTROL RHEOSTAT
1. Install the light control rheostat with the 2 screws.
  
  Fig 1: Install The Light Control Rheostat With The 2 Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 36
INSTALL NO. 1 SWITCH HOLE BASE . Refer to INSTALLATION - Step 37
INSTALL INSTRUMENT PANEL GARNISH LH . Refer to INSTALLATION - Step 38
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Air Suspension)
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
INSPECT SUSPENSION CONTROL SYSTEM (w/ Air Suspension)
1. Inspect the suspension control system. Refer to TEST MODE PROCEDURE .