LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> RX 350 FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display (Service Information) >> HEADUP Display >> REMOVAL (From 8/2009) >> Removal

REMOVAL (From 8/2009): Removal

  1. PRECAUTION (w/ Navigation System for HDD) 
    NOTE:

    After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    1. Disable the auto tilt away function by changing the customize parameter. Refer to CUSTOMIZE PARAMETERS .
      NOTE:

      Record the current customize parameter setting (whether the auto tilt away function is enabled or disabled) in order to restore the current setting after finishing this operation.

      HINT: 

      Performing the above operation disables the auto tilt away function when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.
    3. Turn the engine switch off and disconnect the cable from the negative (-) battery terminal.
      NOTE:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  3. REMOVE INSTRUMENT PANEL GARNISH LH  . Refer to REMOVAL - Step 22
  4. REMOVE NO. 1 SWITCH HOLE BASE  . Refer to REMOVAL - Step 23
  5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  . Refer to REMOVAL - Step 24
  6. REMOVE NO. 1 INSTRUMENT PANEL HOLE COVER  . Refer to REMOVAL - Step 27
  7. REMOVE NO. 2 INSTRUMENT PANEL HOLE COVER  . Refer to REMOVAL - Step 28
  8. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL  See step  8
  9. REMOVE COMBINATION METER ASSEMBLY  See step  9
  10. REMOVE COMBINATION METER MIRROR ECU 
    1. Disconnect the connectors.
      Fig 1: Disconnect the connectors
      GTY258690Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 screws.
      Fig 2: Remove the 2 screws
      GTY258503Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Pull out the No. 1 heater to register duct in the order indicated in the illustration.
      Fig 3: Pull out the No. 1 Heater To Register Duct In The Order Indicated
      GTY274051Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the connector.
      Fig 4: Disconnect The Connector
      GTY257720Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Disengage the clamp.
    6. Remove the 4 screws and combination meter mirror ECU.
      NOTE:

      Do not drop the screws.

scientia non olet · About LEMON Manuals