INSTALLATION (To 8/2009): Installation

INSTALL COMBINATION METER MIRROR ECU
1. Install the combination meter mirror ECU with the 4 screws.
  
  Fig 1: Install The Combination Meter Mirror ECU With The 4 Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Make sure that the ECU is installed securely.
  - Do not drop the screws.
2. Engage the clamp.
3. Connect the connector.
4. Insert the No. 1 heater to register duct in the order indicated in the illustration to temporarily install it.
  
  Fig 2: Insert the No. 1 Heater To Register Duct In The Order
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Install the No. 1 heater to register duct with the 2 screws.
  
  Fig 3: Install the No. 1 Heater To Register Duct With The 2 Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Connect the connectors.
  
  Fig 4: Connect The Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL COMBINATION METER ASSEMBLY See step 1
INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL See step 2
INSTALL NO. 2 INSTRUMENT PANEL HOLE COVER . Refer to INSTALLATION - Step 33
INSTALL NO. 1 INSTRUMENT PANEL HOLE COVER . Refer to INSTALLATION - Step 32
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 36
INSTALL NO. 1 SWITCH HOLE BASE . Refer to INSTALLATION - Step 37
INSTALL INSTRUMENT PANEL GARNISH LH . Refer to INSTALLATION - Step 38
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
- Make sure that the cable has been disconnected from the negative (-) battery terminal for at least 2 seconds before reconnecting the cable.
- Reset the auto tilt away function setting to the previous condition by changing the customize parameter. Refer to CUSTOMIZE PARAMETERS .
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
INSPECT SUSPENSION CONTROL SYSTEM (w/ Air Suspension)
1. Inspect the suspension control system. Refer to TEST MODE PROCEDURE .