INSTALLATION (To 8/2009): Installation

INSTALL COMBINATION METER ASSEMBLY
1. Connect each connector.
2. Install the combination meter assembly with the 2 screws.
  
  Fig 1: Install The Combination Meter Assembly With The 2 Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL
1. Engage the 4 clips and 2 guides.
  
  Fig 2: Engage The 4 Clips And 2 Guides
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the No. 1 instrument cluster finish panel with the 2 clips and 2 screws.
INSTALL NO. 2 INSTRUMENT PANEL HOLE COVER . Refer to INSTALLATION - Step 33
INSTALL NO. 1 INSTRUMENT PANEL HOLE COVER . Refer to INSTALLATION - Step 32
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 36
INSTALL NO. 1 SWITCH HOLE BASE . Refer to INSTALLATION - Step 37
INSTALL INSTRUMENT PANEL GARNISH LH . Refer to INSTALLATION - Step 38
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
- Make sure that the cable has been disconnected from the negative (-) battery terminal for at least 2 seconds before reconnecting the cable.
- Reset the auto tilt away function setting to the previous condition by changing the customize parameter. Refer to CUSTOMIZE PARAMETERS .
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
INSPECT SUSPENSION CONTROL SYSTEM (w/ Air Suspension)
1. Inspect the suspension control system. Refer to TEST MODE PROCEDURE .