DTC B2414: Steering Position Sensor Malfunction: Procedure

CHECK FOR DTC
1. Clear the DTCs. Refer to DTC CHECK / CLEAR .
2. Check for DTCs. Refer to DTC CHECK / CLEAR .
  OK
  
  DTC B2414 output does not occur.
NG → See step 2

OK → See step 4
REPLACE STEERING ANGLE SENSOR
1. Temporarily replace the steering angle sensor with a new or normally functioning one. Refer to REMOVAL - Step 10 .
NEXT: Go to next step
CHECK FOR DTC
1. Clear the DTCs. Refer to DTC CHECK / CLEAR .
2. Recheck for DTCs. Refer to DTC CHECK / CLEAR .
  OK
  
  DTC B2414 output does not reoccur.
NG → See step 5

OK → END (STEERING ANGLE SENSOR IS DEFECTIVE)
USE SIMULATION METHOD TO CHECK. Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE
REPLACE AFS ECU. Refer to REMOVAL