Back-up Light does not Illuminate: Procedure

1. Remove the park/neutral position switch. Refer to INSPECTION .
   Fig 1: Identifying Park/Neutral Position Switch Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Connection
   2 (RB) - 1 (RL)	Shift lever in R	Below 1 Ω
   2 (RB) - 1 (RL)	Shift lever not in R	10 kΩ or higher

NG → See step   4 

OK: Go to next step 

1. Disconnect the C19 switch connector.
   Fig 2: Identifying C19 Switch Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   C19-2 (RB) - Body ground	Engine switch on (IG)	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Disconnect the C19 switch connector.
   Fig 3: Identifying C19 Switch f4 And f5 Light Connectors

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the f4 and f5 light connectors.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   for LH 

   for LH 

   Tester Connection	Condition	Specified Condition
   C19-1 (RL) - f5-1	Always	Below 1 Ω
   f5-2 - Body ground
   f5-1 - Body ground	Always	10 kΩ or higher

   Tester Connection	Condition	Specified Condition
   C19-1 (RL) - f4-1	Always	Below 1 Ω
   f4-2 - Body ground
   f4-1 - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   5